ClearPath™ Sleeve
Introduction
The ClearPath™ Sleeve is a non-rotating stabilizer sleeve that gives you 360° wellbore contact through six to eight stabilizing points.
Fore-and-aft stabilization keeps the assembly centered throughout the run. Full wellbore engagement cuts vibration, extends sleeve life, and supports higher ROP. Low-friction, dome-shaped blades reduce torque and drag, while a hydrodynamic recess profile keeps cuttings moving past the tool.
Every sleeve is bespoke. Taper angle, blade contact area, and fluid bypass area are designed around your specific operation.
Consistent Hole Contact
Six to eight stabilizing points hold the assembly centered from spud to total depth, in mud motor and directional assemblies alike.
Reduced Torque and Drag
Low-friction, dome-shaped blades and optimized taper angles improve sliding yields in deviated and high-torque wells.
Designed Around your Well
Blade contact area and fluid bypass area are configured to your operational needs, not fixed to a catalog spec.
How It Works
Contact Without the Wear
A sleeve under constant wellbore contact takes on vibration, torque, and drag with every rotation. Left unmanaged, that wear shortens sleeve life and slows the run.
The ClearPath™ Sleeve spreads that load across six to eight discrete stabilizing points instead of a continuous spiral blade. Low-friction, dome-shaped blades and optimized taper angles reduce the friction at each point, while a hydrodynamic recess profile keeps cuttings clearing past the tool rather than packing around it.
The result is consistent hole contact for the length of the run: less vibration, longer sleeve life, and higher ROP, with sliding yields improved by the reduced torque and drag.
ClearPath™ Videos
4 Design Changes That Help You Slide Further | ClearPath
Keep Flow Rates Below Frac With a Better RSS Sleeve | ClearPath
Cleaner Hole, Lower Pressure Drop: RSS Sleeve in 60 Seconds
Related solutions
Further enhance your wellbore quality
Drive drilling efficiency with advanced wellbore solutions
View all productsMechLok®
Lockable Drill Pipe Swivel
Mechanically lockable swivel that rotates pipe above the liner, reducing drag and buckling to push completions to depth.
Drill-N-Ream®
Ultimate Wellbore Conditioning Tool
Reduce torque and drag, extend your lateral reach, and eliminate the need for dedicated reamer runs.
TurboCaser®
High-Speed Reaming System
A pass-through, turbine-powered reamer shoe system that lands casings and intermediate liners at target depth, no string rotation required.
ClearPath™ Stabilizer
Next-Generation Stabilization
Dome-shaped, low-friction blades centralize the BHA while reducing torque, drag, and torsional vibration, a direct spiral-blade replacement.
TurboRunner®
Completion Running System
Turbine-powered reaming that lands completions, liners, and casings at target depth, gentle on delicate and intelligent strings.
Dome Hybrid Reamer
Stabilize & Ream on Demand
A dual-function tool that stabilizes the BHA during normal drilling and reams on demand, reaming when you need it.